316 SS Inline Duct Heater up to 430°C - Power: 150/600 W, Supply voltage: 120/240 Vac

Specify product selection
Variant does not exist

€ 614.30 excl. VAT
can be ordered - date of dispatch to be specified
qty

Item# (PN): AHPF-082 Shipping and Payment

OMEGA Engineering

Air/Gas Flow up to 425 LPM (l/min). Air/Gas Outlet Temperatures up to 430°C. Pressures up to 100 PSI. Inlet Male 3⁄8" NPT, Outlet 1⁄2" NPT. 316 Stainless Steel Construction. More

The AHPF series heaters are used to heat low flows of air, gas, water, or aqueous solutions. Applications include those where clean air is necessary, as in laboratories and environmental testing areas. The stream of air is heated by passing over an enclosed heated surface rather than directly over resistance elements. This method assures that no foreign matter will enter the stream of flow. The AHPF series is also used as a miniature circulation heater for small volume liquids as in photographic developer solution, chemicals, dyes, and inks.

The Thermocouple “T” fitting AHPF-NPT12 can be used with the subminiature thermocouple probes and with the SSLK series stainless steel compression fittings (see the OMEGA Complete Temperature Measurement Handbook and Encyclopedia®) and with stainless steel compression fittings (model SSLK-18-14) to monitor or control temperature at the outlet of the AHPF series heaters.

SPECIFICATIONS:

Cross Sectional Area: 0.152 sq. inches
Pressure Rating: Up to 100 PSIG
Wattage Tolerance: +5, -10% or better at the voltage specified
Outside Diameter: 11/4' (32 mm)
Inlet: Male 3/8' NPT
Outlet: 1/2' NPT

Complete informations can be found in the spec sheet (PDF), see the "Download" section.

AHPF_spec_sheet.pdf (pdf, 259.7 kB)
AHPF_en_manual.pdf (pdf, 336 kB)